Hi all, Back again, I have been working directly with Microsoft feeding any information they needed to rectify the problem. Hope this works for anyone else running into this problem.

I'm sure they'll have this all sorted out before the RTM client comes out. I printed the Windows test page and some color documents and it works fine. I corrected this and saved the port configuration. When I did this, Windows omitted the last octet and hence could not talk to the printer. Make the sure the printer is mapped as 'Raw'. Under 'Ports', select the port that has been created for the IP address you used to add this printer and click Configure Port. I am using Konica-Minolta BizHubs site wide, so I picked that network card 5) Windows then asked me to specify a driver and I picked the C200 driver (same driver as the C203 I'm installing) 6) Windows asked if I'd like to name the printer which I did and clicked Finish 7) After the printer has been added, go to the Printer Properties and click on the 'Ports' tab. 4) Windows will ask for the type of network card in the printer. 1) Run the Add Printer Wizard and pick Network Printer 2) After Windows does it's search, add the printer via the IP address 3) After entering the IP address, Windows may indicate it did not find the printer. At any rate, I had the same problem as listed above and figured out a way to get the printer installed. Sorry, I thought the link said 'Propose An Answer' not 'Propose As Answer' for the previous item in this thread.

Change ip address on hp laserjet p4015n